printer_wizard_window
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
printer_wizard_window [2018/10/29 18:00] pjr [Optional/Advanced Settings] |
printer_wizard_window [2020/01/07 12:07] (current) pjr [Optional/Advanced Settings] |
||
|---|---|---|---|
| Line 25: | Line 25: | ||
| * **Nozzle Bore Length** | * **Nozzle Bore Length** | ||
| - | * Enter the bore (aka "throat") length in millimetres. Note that the bore length on modern nozzles is usually between 1.5 a 2 times the nozzle diameter | + | * Enter the bore (aka "throat") length in millimetres. Note that the bore length on modern nozzles is usually 1½ to 2 times the nozzle diameter |
| * **Drive Length** | * **Drive Length** | ||
| * Enter the distance between the filament drive gear and the nozzle tip in millimetres | * Enter the distance between the filament drive gear and the nozzle tip in millimetres | ||
printer_wizard_window.1540832405.txt.gz · Last modified: 2018/10/29 18:00 by pjr
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
